Build list for Mazda 3

[Tracker]

Current list is pretty much complete but still i want to add another section containing a budget build for an all motor setup and a turbo setup, so until then thread is closed :P Mild: Balance shaft delete kit (2.3l only) Short or cold air Intake Cat back exhaust Stage 1 clutch (manual) Lightweight flywheel (manual) Oil filter conversion (2.3l only) Stiffer rear engine mount Ground kit Lowering springs Strut bar Short shifter NGK plugs Decent brake pads (EBC, Hawk, etc.) Lightweight crankshaft pulley (You MUST tq to 80ft pds and then turn the nut an additional 90 degrees using a breaker bar) Wild: Stage 2 clutch Lightweight accessory pulleys Tq dampener Stiffer trans mount Valvebody upgrade (autotradgics only) A/F controller Intake mani Header Shocks Accelerator lag reducer (electronic throttlebody only) Launch controller Extreme: Oil sump Polished and rebalanced crank to desired rpm Forged rods and pistons Head gasket Valvetrain upgrade Cam and cam gears Standalone EMU Re-enforced trans gears (manual) Tq converter (auto) Spec clutch Performance radiator and fans Turbo kit Supercharger (eventually...maybe) Stiffer drivers side engine mount Coilovers Cable throttle body conversion High output Injectors LSD Budget turbo build: Low compression forged pistons 9.1 (stay at 15psi max) Forged rods Rod bearings Ebay turbo kit (replace wastegate and bov) ARP head studs AEM Fuel and Ignition F/IC 8 2.5in exhaust Stage 1 clutch Lightweight flywheel Lightweight crankshaft pulley (See above note) Mazdaspeed short shifter Stiffer rear engine mount All motor build: Forged pistons Forged Rods (12.5:1 if u want to stay with reg pump gas, 14:1 is for 103 and up octane) Rod bearings Head gasket ARP head studs Full 2.5in exhaust 4-2-1 Header (A 4-1 header will decrease back-pressure therefore destroying low end power) Lightweight crankshaft pulley Valvesprings Valves Standalone EMU 550cc and up injectors Intake manifold or custom ITB Stage 1-3 clutch Lightweight flywheel Short shifter *Note: As of now there is no budget all motor build worth making

Register today for free or log-in if already registered to remove this ad!